7 Signs Your Induction Furnace Lining Needs Replacing
Know when to reline. These warning signs show an induction furnace lining is wearing thin or failing.
Running a lining too long risks a breakout. Relining too early wastes material and production time. These signs help you judge.
1. Ground leak detector warnings
If your furnace has an earth leakage or ground leak detection system, rising readings or alarms are a serious signal. Follow the furnace maker's instructions.
2. Measured wall thickness is low
Many shops measure the inside diameter of the empty furnace after a set number of heats. When the wall reaches the minimum the furnace maker allows, it is time.
3. Rising power use per tonne
A thinner wall can change electrical behaviour and heat loss. A steady rise in units per tonne can point to lining wear.
4. Hot spots on the coil or shell
Unusual temperature readings, discoloured coil insulation or local heating outside the lining need immediate attention.
5. Visible cracks or metal penetration
Some fine cracking is normal. Deep cracks, metal fins in cracks, or penetration at the slag line are not.
6. Erosion at the slag line
The band where slag sits often wears fastest. A visible groove here limits lining life.
7. Bulging or uneven wear
An uneven wall can mean the former was off-centre or the ramming was uneven.
Keep a lining log
Record heats, power, readings and observations for every campaign. You will see your typical lining life, and anything unusual stands out quickly.