Skip to content
GOLDENRefractories Pvt. Ltd.

Boron Oxide vs Boric Acid in Ramming Mass: What Changes?

Both binders help a silica lining sinter. Here is how boron oxide (B₂O₃) differs from boric acid (H₃BO₃) in a ramming mass.

B2O3BINDERS

Silica ramming mass needs a binder so that the hot face sinters into a strong layer during the first heat. For years the usual choice has been boric acid. A newer option is to use boron oxide directly.

What the binder actually does

As the lining heats up, boron oxide reacts with the surface of the silica grains and forms a borosilicate glass. That glass flows into the tiny gaps between grains and bonds them together at a lower temperature than silica alone would need.

Boric acid: the usual route

Boric acid (H₃BO₃) is not the binding phase itself. It must first lose its water in the heat, step by step, before it becomes boron oxide. That water has to leave the lining during preheating.

Boron oxide: the direct route

With boron oxide (B₂O₃), the active binding phase is present from the start. There is no water of decomposition to drive off from the binder.

Potential benefits melt shops look for

  • A denser, stronger sintered layer.
  • Better resistance to erosion and slag attack.
  • Less risk of cracking during preheating.
  • The potential for a longer lining campaign.

Results always depend on the furnace, the sintering schedule, the charge and the operating practice, so compare grades on your own furnace over several campaigns.

Which should you use?

If your current boric acid premix works well, there is no need to change for the sake of it. If you are fighting early cracking or short campaigns, a boron oxide grade is worth a trial.

Golden Refractories makes both. Ask us for a trial quantity.